Clear glass, quiet craft: the XQ2 Elbow Adapter with glass screen forms the base of the tube and joins it to the Cyclone Bowl on Arizer desktops.
Some parts are seen, others are felt. The XQ2 Elbow Adapter is both. It is a clear glass elbow at the base of the tube, and it joins the tube to the Cyclone Bowl with a quiet, close fit. A glass screen comes with it, so the joint stays glass from end to end.
Glass gives the purest look on a desk, and it also lets you see the state of the part. Residue shows at once, so care never comes as a surprise. For the science of heat-resistant lab glass, the entry on borosilicate glass is a fine read.
Arizer is known for its desktop units, and this part serves three of them. It fits the Arizer XQ2, the V-Tower and the Extreme Q. On the Extreme Q it pairs with either the long or the short tube.
Warm the tube with hot water until it is soft. Then slide it straight onto the small end of the adapter, and stop when the fit is snug. A calm, straight push respects the glass, and it keeps the joint true, close and even on all sides.
Soak the adapter in a diluted cleaning solution. After that, brush it with pipe cleaners, rinse, and let it dry fully. The glass screen follows the same routine, so the aroma path stays clear.
What completes an all-glass path? Combine the adapter with the XQ2 glass connoisseur bowl and an Arizer glass aroma tube.
Is the XQ2 Elbow Adapter supplied with its glass screen? Yes, the adapter arrives with a glass screen, as its name states.
How do I know the fit is right? When the warm tube sits snug and even on the small end, the joint is ready.